Thermal Grizzly Kryonaut VS Kingpincooling KPx Thermal Paste LN2 Face-off (by Splave)
To start, both pastes besides color (duh) are not very similar at all. Grizzly is rather thin and will slightly flow if you were to set a ball of it on a flat surface. Blue paste is extremely thick and holds its form 100%. Now lets talk about the feel. As you spread Kryonaut, it’s akin to spreading a glaze of sorts. It is extremely smooth with some snags once in a while from a stray aluminum particle here and there. KPx paste is more like smooth peanut butter with a bit of melted candle wax aspect added in. KPx is rather difficult to spread, adding some heat to the processor or even to the thermal paste itself can help alleviate this a bit but for spread ability Kryonaut is in the lead.
- Intel Core i7 7700K processor
- ASRock Z170M OC Formula
- Custom Direct Die CPU pot
6840MHZ r15 KPx tim Best of 3 mounts
6877MHZ r15 Kryonaut Best of 3 mounts
Guess what? All thermal pasts will crack under extreme conditions. They all do … alllll of them. Maybe you will get lucky or maybe you are one of those guys that think they have the magic cure but that is all delusion. Since we have the out of the way now, let’s compare. Over the course of 20 mounts Kryonaut has given me 5 crack free sessions. KPx has cracked all but twice.
Let’s go deeper. Kryonaut seems to be extremely predictable on the cracking. On the first cool down to -196 80% of the time it will snap. What I have found though is that it will rarely ever snap again in the session. Pull down to full pot, let it snap, heat up to 70c, pull back down to -196 and bench. Golden. KPx seems to snap randomly and usually when idle or after coming out of a heavy load. The edge once again goes to Kryonaut.
Kryonaut is clearly better at full pot Frequency and predicting/manipulation of the snap. So let’s try to figure out why.
When we pull the mount we can see why. It seems the Blue paste is just too stiff and it almost seems to peel away. It also gets very gritty under the stress of LN2. The Kryonaut seems to form almost a suction to the pot because it’s so loose and doesn’t change its form at all and seemingly you would not even know its been used yet.
The tests using direct die are very telling and supremely accurate. There is only one surface being mated by the thermal paste and it is one that is impossible to create error as opposed to using an IHS where mounting can vary greatly depending on where it settles how much it slides etc. The very small die of Kaby lake does not give very much surface area at all making it a very hard task on the thermal paste.
But after comparing the two on the same exact setup Kryonaut is the clear winner in every regard.