Service Hotline: +86-755-23778007
You are here:Home >> Products >> RED PLASTIC

Products

Products

follow Us

Mail sales@sztensan.com
Contact: Mark Chang
Wecha/whatsappt:13688843969 
Tel:86-755-23778007
Office Address:longhua district  Shenzhen   
Factory Address:A28 Tangjia road  Guangming new district  shenzhen 

RED PLASTIC

SMT RED PLASTIC

Tensan TS6209 SMT red plastic is a one-component epoxy adhesive,which can fast cure at high temperature .It is designed for SMD components on printed circuit board bonding. TS6209 has excellent thixotropy, suitable for high-speed SMT placement machine Dispensing and stencil printing. It is of high adhesive strength after curing .

  • 1. Product introduction and application

    Tensan TS6209 SMT red plastic is a one-component epoxy adhesive,which can fast cure at high temperature .It is designed for SMD components on printed circuit board bonding. TS6209 has excellent thixotropy, suitable for high-speed SMT placement machine Dispensing and stencil printing. It is of high adhesive strength after curing .

     

    2. Pre-curing material

    Appearance

    Red gel

    Yield value25pa

    600

    Proportion25g/cm3

    1.2

    Viscosity5rpm 25

    350000

    Thixotropic index

    6.8

    Flash pointTCC

    >95

    Particle size

    15um

    Copper mirror corrosion

    No corrosion

     

    3. Storage conditions

    2-8℃, cool and dry place, it can be stored for 6 months; room temperature (25℃), it can be stored for 1 month.

     

    4. Instructions and precautions

    Cold storage TS6209 to be rewarmed before use, 30ml syringe to be 1 hour, 300ml 24 hours. Storage tank or dispensing mouth temperature at 25℃-30℃ can help improve the high-speed dispensing effect.

    Precautions:

    1In order to avoid contaminating unused glue, any glue can not be back into the original packaging.

    2Glue placing in the air will absorb trace moisture performance, which will influence the properties of glue, so it should be avoided. In the stencil printing, do not put SMT printed circuit board in the air for too long,  patch curing as soon as possible, if possible, air humidity should be controlled.

     

  • Please fill out the information, we will reply as soon as possible

    *

    *

    *

    *

Contact us